Lenovo thinksystem SN850 7X15, Руководство по установке

Страница: 41 / 88

The compute node has four drive bays for installing hot-swap drives. One drive might already be installed in
the compute node. If the compute node is equipped with one drive, you can install up to three additional
drives.
See “RAID configuration” on page 65 RAID configuration for instructions.
To install a 2.5-inch hot-swap drive, complete the following steps:
Watch the procedure . A video of the installation process is available:
• Youtube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-DtV8A4UWy7d3AoFKjCvas3
• Youku: http://list.youku.com/albumlist/show/id_50481024
Figure 13. 2.5-inch hot-swap drive installation
Table 11. 2.5-inch hot-swap drive and related components
1
Release latch
4
Drive bay filler
2
Drive activity LED (green)
5
Drive
3
Drive status LED (yellow)
6
Release handle
Step 1. Identify the drive bay in which you plan to install the hot-swap drive.
Step 2. If a drive bay filler is installed, pinch the grip point and pull it away from the compute node.
Step 3. Touch the static-protective package that contains the hot-swap drive or solid-state drive to any
unpainted metal surface on the Flex System chassis or any unpainted metal surface on any other
grounded rack component; then, remove the drive from the package.
Step 4. Open the release handle on the drives into the bay until the release handle catches on the bezel,
then rotate the handle to fully seat the drive.
Step 5. Lock the drives into place by closing the release handle until it clicks.
Step 6. Check the drive activity LEDs to make sure that the drive is operating correctly.
Chapter 3
.
Compute node hardware setup
33