Lenovo ThinkAgile HX2320 Appliance, Руководство пользователя

Страница: 91 / 100

Appendix A. Configuration procedures
Lenovo recommends the following UEFI settings for Lenovo ThinkAgile HX Series appliances.
The following procedure will configure the systems to the recommended levels:
1. Set UEFI to default settings:
OneCli config loaddefault UEFI
2. Set the following values:
OneCli config set BootModes.SystemBootMode "Legacy Mode"
OneCli config set SystemRecovery.F1StartControl "Text Setup"
OneCli config set OperatingModes.ChooseOperatingMode "Maximum Performance"
Notes:
• The use of OneCLI above is for illustration purposes only. Configuring through F1 Setup at boot time
works as well. Refer to the system documentation or OneCLI documentation for more information. Power
on/reboot is necessary for the UEFI changes to take effect.
• Refer to the following web page for the full list of ThinkAgile HX UEFI settings:
https://support.lenovo.com/us/en/solutions/HT507780
• For VMWare clusters, it is possible that EVC (Enhanced vMotion Compatibility) could be affected by some
UEFI settings. It might be necessary to change some settings, like MONITORMWAIT, from the
recommended values below, to allow EVC to function as desired.For more information on VMWare's EVC,
refer to this article:
https://kb.vmware.com/s/article/1003212
Configure boot order
Use OneCLI to configure the boot order as follows:
1. CD/DVD Rom
2. Hard Disk 0
3. PXE Network
OneCli config set BootOrder.BootOrder="Legacy Only=CD/DVD Rom=Hard Disk 0=PXE Network"
Configure M.2 mirrorring
The M.2 adapter must be configured with a RAID 1 mirrored virtual drive to allow the Hypervisor to be
installed for booting.
Use OneCLI to configure the M.2 adapter:
[m.2]
#RAID level. RAID level can only be 0 or 1.
raid_level=1
#vol_name.the name of vol.
vol_name=volume0
#Strip Size. Unit:KB. stripe size can only be 32k or 64k.
strip_size=64K
© Copyright Lenovo 2019
87