Lenovo ThinkAgile HX2320 Appliance, Руководство пользователя

Страница: 36 / 100

Note: The Lenovo XClarity Controller USB connector mode must be set to manage the Lenovo XClarity
Controller (instead of normal USB mode). To switch from normal mode to Lenovo XClarity Controller
management mode, hold the blue ID button on the front panel for at least 3 seconds until its LED flashes
slowly (once every couple of seconds).
To connect using the Lenovo XClarity Administrator Mobile app:
1. Connect the USB cable of your mobile device to the Lenovo XClarity Administrator USB connector on
the front panel.
2. On your mobile device, enable USB tethering.
3. On your mobile device, launch the Lenovo XClarity Administrator mobile app.
4. If automatic discovery is disabled, click Discovery on the USB Discovery page to connect to the
Lenovo XClarity Controller.
For more information about using the Lenovo XClarity Administrator Mobile app, see:
http://sysmgt.lenovofiles.com/help/index.jsp?topic=%2Fcom.lenovo.lxca.doc%2Flxca_usemobileapp.html
Important: The Lenovo XClarity Controller is set initially with a user name of USERID and password of
PASSW0RD (with a zero, not the letter O). This default user setting has Supervisor access. Change this user
name and password during your initial configuration for enhanced security.
Complete the following steps to connect the Lenovo XClarity Controller to the network using the Lenovo
XClarity Provisioning Manager.
Step 1. Start the server.
Step 2. When you see <F1> Setup, press F1.
Step 3. Specify how the Lenovo XClarity Controller will connect to the network.
• If you choose a static IP connection, make sure that you specify an IPv4 or IPv6 address that is
available on the network.
• If you choose a DHCP connection, make sure that the MAC address for the server has been
configured in the DHCP server.
Step 4. Click OK to continue starting the server.
32
User Guide for ThinkAgile HX2320 Appliance and HX2321 Node