Lenord, Bauer GEL 8310, Руководство по эксплуатации, Страница: 156 / 226

A-22 S
TORAGE LOCATIONS FOR MACHINE PARAMETERS
8310/8610-8
3 10
Set ref. Setting of the reference measure
Specifies the direction of travel for the setting of the reference measure when
positioning the drive; refer to section 4.6
0 inactive the setting of the reference measure is disabled
1 forward the reference measure will be set when moving the drive in
the forward direction
2 reverse the reference measure will be set when moving the drive in
the reverse direction
3 forw/rev the reference measure will be set irrespective of the
direction of travel
3 11
Auto cal
Automatic reference search routine
Specifies the direction of motion for setting the reference measure for the auto-
matic reference search routine (auto calibration). This can only be initiated in the
reset state of the unit and if High level is applied to the corresponding stop input;
refer to section 4.6
0 inactive search routine is disabled
1 autoforw setting the reference measure in the forward direction
2 auto rev setting the reference measure in the reverse direction
3 12 Fine Reference fine signal
Specifies the switching direction of the reference fine signal; refer to section 4.6
0
f
edge
negative signal edge (High
→
Low) is evaluated
1
d
edge
positive signal edge (Low
→
High) is evaluated
2
df
edge
both signal edges are evaluated
3 13 Coarse Reference coarse signal
Specifies the switching state of the
reference coarse
signal; refer to section 4.6
0 low
Low level =^ logical 1
1 high
High level =^ logical 1