9
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
LENNOX MERIT
®
SERIES B-VENT GAS FIREPLACES • 36" LMBV MODELS • CARE AND OPERATION INSTRUCTIONS
Figure 12
Proper log placement is critical to prevent soot-
ing. Carefully position the ceramic fiber logs
over the burner as described in the following
steps, and detailed in Figures 11 through 15.
Note: Logs should be placed in the gaps between
the flame peaks and should be positioned so
that at no time they impinge the flames.
Step 1
. Remove the rockwool from the pack-
aging and tear into nickel size pieces. Spread
the rockwool evenly on top of the burner. Do
not use more than is necessary. The rockwool
should not cover the burner ports, as shown
in Figure 10.
Step 2.
Place the hole at the bottom of the Rear
Log over the pin at the rear of the log grate, as
shown in Figure 11. The log should rest against
the back refractory.
Step 3.
Place the Rear Top Log over the left
side of the Rear Log. Lay the log over the
top left corner of the Rear Log, as shown in
Figure 12. The log should rest against the
back refractory.
Figure 13
logs and Rockwool Placement
Figure 14
WARNING: lOGS GET vERy HOT AND
WIll REmAIN HOT UP TO ONE HOUR
AFTER GAS SUPPly IS TURNED OFF.
HANDlE ONly WHEN lOGS ARE COOl.
TURN OFF All ElECTRICITy TO THE AP-
PlIANCE bEFORE yOU INSTAll GRATE
AND lOGS.
WARNING: THIS APPlIANCE IS NOT
mEANT TO bURN WOOD. ANy ATTEmPT
TO DO SO COUlD CAUSE IRREPARAblE
DAmAGE TO yOUR APPlIANCE AND
PROvE HAzARDOUS TO yOUR SAFETy.
WARNING: THE SIzE AND POSITION ON
THE lOG SET WAS ENGINEERED TO GIvE
yOUR APPlIANCE A SAFE, RElIAblE
AND ATTRACTIvE FlAmE PATTERN.
ANy ATTEmPT TO USE A DIFFERENT
lOG SET IN THE FIREPlACE WIll vOID
THE WARRANTy AND WIll RESUlT IN
INCOmPlETE COmbUSTION, SOOTING,
AND POOR FlAmE QUAlITy.
Figure 11
Figure 15
Figure 10
Rear log
Rear Top log
Front left log
Front Right log
Top Right log
Rear log
Step 4.
Engage the bottom hole of the Front
Left Log with designated pin on the grate, and
align the bottom groove of the log over the far
left grate bar. See Figure 13.
Step 5.
Engage the bottom hole of the Front Right
Log with designated pin on the far right grate bar.
Align the groove on the bottom of the log over
the far right grate bar. See Figure 14.
Step 6.
Engage the bottom hole of the Top
Right Log, over the pin on the Front Right Log.
Rest the upper portion of the log in the notch
of the Rear Log. See Figure 15.
Front Right log Pin
Notch In Rear log
Front Right log Pin
burner Ports
Rockwool
Rear log Pin
