12
IMPORTANT
The compressor in this unit contains PVE
oil (Polyvinylether). PVE oil is formulated for
hydrofluorocarbon (HFC) refrigerants, such as HFC-
410A, which this system contains. While it may have
some miscibility properties with mineral-based oil and
POE oil (Polyolester), it is not recommended to mix PVE
oil with any other type of refrigerant oil.
16. Align the threaded connections with the
flared refrigerant lines. Tighten the flare nuts
lightly at first to obtain a smooth match as
illustrated in “Figure 19. Making Connections
(Male to Female Connection)”.
Table 3. Refrigerant Piping and Indoor Unit
Connection Sizes
Size
(Btuh)
Liquid Line
in.
Gas Line
in.
12000
1/4
1/2
A
B
CANT ON THE OUTSIDE OF
THE FLARE
MALE FLARE
CONNECTION
Figure 19.
Making Connections
(Male to Female Connection)
17.
Once snug, continue another half-turn on each nut
which should create a leak-free joint. A torque wrench
may be used to tighten flare nuts using “Table 4. Flare
Nut Torque Recommendations” on page 12.
Do
not over-tighten a flared joint. Flared connections
should always be accessible and must be insulated
to prevent condensation.
18. After refrigerant piping has been installed and checked
for leaks, apply insulation over all flared connections.
TORQUE WRENCH
TO INDOOR
UNIT
TO OUTDOOR UNIT
BACKUP
WRENCH
Figure 20.
Tighten Flare Nut
Table 4.
Flare Nut Torque Recommendations
Outside
Diameter
Recommended
Torque
No torque wrench available
Finger tighten and use an
appropriately sized wrench to
turn an additional:
Inches
1/4
15 ft.-lb. (20 N)
1/4 turn
1/2
41 ft.-lb. (56 N)
7/8 turn
