Lennox Hearth Products Traditions T300P Series, Инструкция по установке и эксплуатации

Страница: 7 / 40

INSTALLATION
Page 7
MANUFACTURED (MOBILE) HOME INSTALLATION
Model –T300P Series
In addition to the standard installation instructions, the
following instructions may be required by local, state or
federal building codes:
•
Stove must be permanently bolted to the floor.
•
An outside air inlet must be provided for combustion
and be unrestricted while unit is in use.
•
Stove must be permanently electrically grounded to
the steel chassis of the home. The location selected
for ground attachment to the stove must be dedicated
for this purpose.
•
See pages 10 through 15 for additional information on
venting requirements.
•
Do not install appliance in a sleeping room.
•
The structural integrity of the manufactured home
floor, walls, ceiling and roof must be maintained.
NOTE: The grounding of this product, at installation,
must comply with NFPA-70 standards, CSA C22.1 in
Canada, as well as any local codes.
Model - T300P SERIES
MANUFACTURED (MOBILE) HOME EXHAUST VENT
PIPE INSTALLATION GUIDELINES
Use only listed type “PL” pellet vent pipe. Pipe should
extend at least 3 feet above the part of the roof through
which it passes. The top of the pipe should be at least 2
feet above the highest required elevation of any part of
the manufactured (mobile) home within 10 feet of the
pipe.
If the exhaust vent exits the manufactured (mobile)
home at a location other than the roof, and exits at a
point 7 feet or less above the ground level on which the
manufactured (mobile) home is position a guard or
method of enclosing the pipe shall be provided at the
point of exit for a height of up to 7 feet. The openings, if
any, in this guard shall not allow a 3/4” rod to pass
through. A 1/2” rod could pass through but should not
be able to touch the pipe when inserted through the
opening a distance of 4 inches.
REMOVING APPLIANCE FROM PALLET
1. After removing the packaging from the stove, lift the
hopper lid, and remove all pre-packaged items that
were shipped in the hopper. Next, open the stove
door and remove all pre-packaged items.
2. Remove screws which secure legs to pallet.
INSTALLING LEG LEVELING BOLTS
The four leg leveling bolts (included in accessory pack-
age), are provided for leveling the stove if necessary.
To install, thread the bolts into the existing holes in the
bottom of each leg. Turn the leveling bolts to adjust for
correct height.
INSTALLATION CHECK LIST
It is strongly recommended that you have an authorized
Lennox Hearth Products dealer install your stove. If you
install your stove yourself, you should review your in-
stallation plan with your authorized Lennox Hearth
Products dealer.
Check list:
Check off each item as you proceed with the installation
process.
Read the ENTIRE stove installation section first.
Determine the appropriate measurements and loca-
tions for your installation.
Follow the general installation directions under
Stove Installation and the installation section ap-
propriate to your stove.
Be sure to pre-fit all items before you install, fasten,
or set up the stove permanently.
Prior to lighting your stove:
Review the safety precaution section.
Review the pellet fuels section.
Review and follow the Operating Instructions.
Plug power cord connector into corresponding con-
nector on the back of appliance (see illustration on
page 9 showing connector locations).
After you have begun operation of your stove:
Review the routine cleaning / maintenance informa-
tion.
Enjoy the warmth from your new Lennox Hearth
Products pellet stove!
Chassis
Floor
Floor
Protector Bolt