Lennox Hearth Products Traditions T300P Series, Инструкция по установке и эксплуатации

Страница: 2 / 40

IMPORTANT WARNINGS
CAUTION: Read this manual thoroughly before starting installation. For your safety, follow the installation, op-
eration and maintenance instructions exactly without deviation. Failure to follow these instructions may result
in a possible fire hazard and will void the warranty. If this appliance is not properly installed, a house fire may
result. Contact local building or fire officials about restrictions and installation inspection in your area.
Page 2
1. DO NOT CONNECT THIS UNIT TO A CHIMNEY
FLUE CONNECTED TO ANOTHER APPLIANCE.
2. Do not connect this appliance to air ducts or any air
distribution system.
3. Do not install a flue damper in the exhaust venting
system of this appliance.
4. Do not use class B venting intended for gas appli-
ances as a chimney or connector pipe on a pellet-
fired appliance.
5. The minimum clearances must be maintained for all
combustible surfaces and materials including; fur-
niture, carpet, drapes, clothing, wood, papers, etc.
Do not store firewood within this clearance space.
6. INSTALLATION DISCLAIMER - This stoves exhaust
system works with negative combustion chamber
pressure and a slightly positive chimney pressure.
Therefore, it is imperative that the exhaust system
is gas tight and installed correctly. Since Lennox
Hearth Products has no control over the installa-
tion of your stove, Lennox Hearth Products grants
no warranty, implied or stated for the installation or
maintenance of your stove, and assumes no re-
sponsibility for any consequential damage(s).
7. Burning any kind of fuel consumes oxygen. If out-
side air is not ducted to the appliance, ensure that
there is an adequate source of fresh air available to
the room where the appliance is installed.
8. This stove is not intended for use in commercial
installations other than where the stove is being
sold without prior approval from Lennox Hearth
Products.
9. The stove will not operate using natural draft, nor
without a power source for the blower and fuel
feeding systems.
10. Never use gasoline, gasoline-type lantern fuel,
kerosene, charcoal lighter fluid, or similar liquids to
start or "freshen up" a fire in this heater. Keep all
such liquids well away from the heater while it is in
use.
11. CONTINUOUS OPERATION: When operated cor-
rectly, this appliance cannot be overfired. Continu-
ous operation at a maximum burn can, however,
shorten the life of the electrical components (blow-
ers, motors, and electronic controls), and is not
recommended. Typical approved operation would
include running at the low to mid range setting with
occasional running on the maximum setting during
the coldest periods of the winter. The blower speed
control should be turned to high when operating
the stove on the high heat setting.
12. CAUTION: NEVER PUT FINGERS NEAR AUGER.
Pellet fuel is fed to the UltraGrate

by a screw au-
ger. This auger is driven by a high torque motor.
The auger is capable of doing serious harm to fin-
gers. Keep pellets in the hopper at all times and
keep fingers away from auger. The auger can start
and stop automatically at any time while the stove
is running.
13. CAUTION: HOT WHILE IN OPERATION. An appli-
ance hot enough to warm your home can severely
burn anyone touching it. Keep children, clothing
and furniture away. Contact may cause skin burns.
Do not let children touch the appliance. Train them
to stay a safe distance from the unit.
14. APPROVED FUEL: This appliance is designed spe-
cifically for use only with pelletized wood fuels
only. With its advanced UltraGrate

technology,
this appliance is designed and approved for the
burning of wood residue pellets with up to 3% ash
content. This appliance is NOT approved to burn
cardboard, nut hulls, cherry pits, corn, etc. regard-
less if it is in pellet form. Failure to comply with this
restriction will void all warranties and the safety
listing of the stove. Consult with your authorized
Lennox Hearth Products dealer for more informa-
tion on approved pellet fuels.
15. FLY ASH BUILD-UP: For all wood pellet fuel-
burning heaters, the combustion gases will contain
small particles of fly ash. This will vary due to the
ash content of the fuel being burned. Over time, the
fly ash will collect in the exhaust venting system
and restrict the flow of the flue gases. The exhaust
venting system should be inspected regularly and
cleaned as necessary.
16. SOOT FORMATION Incomplete combustion, such
as occurs during startup, shutdown, or incorrect
operation of the room heater will lead to some soot
formation which will collect in the exhaust venting
system. A precautionary inspection on a regular
basis is advisable to determine the necessity of
cleaning. The exhaust venting system should be
inspected regularly and cleaned as necessary.
17. DISPOSING OF ASHES: Any ashes removed from
the pellet stove must be deposited in a metal con-
tainer with a tight-fitting lid. The closed container of
ashes should be placed on a noncombustible floor
or on the ground, well away from all combustible
materials, outside of the dwelling pending final dis-
posal. If the ashes are disposed of by burial in soil
or otherwise locally dispersed, they should be re-
tained in the closed container until all cinders have
been thoroughly cooled.
18. SAVE THESE INSTRUCTIONS.
19. See the listing label on the stove body (or see
Safety / Listing Label, page 38).