Lenel DirecDoor, Руководство по установке

Страница: 16 / 90

Installation, Planning, and Mounting
16
DirecDoor Installation Guide
8.
If using digital outputs, wire the digital outputs to the board. Refer to DO Interface on page 57 .
9.
Test the wiring before you apply power. Refer to Pre-Power Up Testing on page 61 .
10.
Configure your controller. Configure the controller using the Integrated Configuration Tool.
Refer to
Controller Firmware Tools on page 63 .
Safety
Radio Interference
Note: This is an FCC Class A product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate measures.
Electrostatic Discharge (ESD) Precaution
• WARNING! • Circuit board components are vulnerable to damage by electrostatic discharge
(ESD). ESD can cause immediate or subtle damage to sensitive electronic
parts. An electrostatic charge can build up on the human body and then
discharge when you touch a board. A discharge can be produced when walking
across a carpet and touching a board, for example. Before handling any board,
make sure you dissipate your body’s charge by touching ground. This
discharges any static electricity build-up.
General Installation Rules
• WARNING! •
This equipment is to be installed, maintained and serviced by authorized
service persons only.
The authorized installation contractor should comply with the following rules:
•
Neatly label cables at both ends.
(For example, labels should include: controller address number/device or reader number)
•
Use individually shielded pairs of cables only. All wiring must comply with local, state, and
federal electrical codes and fire codes.
•
Obey all national, state, and local electrical and safety codes.
•
Obtain any required permits and/or inspections. Contact the local fire marshal for assistance if
necessary.
•
Safety of customer personnel is the primary consideration of the installation.
•
Neatly dress and tie or lace all wiring in a professional manner.
•
Gather together and tape all unused conductors in multiple conductor cables.
•
Shield all cabling and terminate properly.