Lenel DirecDoor, Руководство по установке

Страница: 65 / 90

DirecDoor Installation Guide
65
Integrated Configuration Tool (ICT)
Initial Configuration
By default, the controller’s IP address is
192.168.6.6
. To have your computer communicate with
the controller, you must set your computer IP address to
192.168.6.5
, or similar valid IP address
(
192.168.6.x
where
x
is any number between 1 and 254 except 6).
1.
In Windows, open the Network and Sharing Center .
For more information, refer to “Using OnGuard in the Supported Operating Systems” in the
Installation Guide.
2.
In the View your active networks section of the form, click the Local Area Connection link.
Note: If you are not currently connected to a network, restore the connection before
continuing. Use the Windows Network Diagnostics tools, or contact your Network
Administrator for assistance.
3.
In the Local Area Connection dialog box, click Properties .
4.
In the Local Area Connection Properties dialog box, select either Internet Protocol Version 4
(TCP/IPv4) or Internet Protocol Version 6 (TCP/IPv6) .
5.
Click Properties .
•
If Obtain an IPvx /Address Automatically is already checked, select Use the Following
IPvx Address , where
x
is the Internet Protocol Version you are using (4 or 6).
•
If the connection is static, write down the IP address and Subnet mask number. You will
need to reset your computer back to these numbers once the controller configuration is
complete.
6.
Enter the IP address,
192.168.6.5
, or a similar valid IP address (
192.168.6.x
where
x
is
any number between 1 and 254 except 6).
7.
Change the Subnet Prefix Length value to
255.255.255.0
. You do not need to change the
default gateway.
8.
Click OK and Close until all open windows are closed.
9.
Connect the computer to the RJ45 connector on the controller’s CPU board using a network hub
or standard Cat 5 cable.
10.
If your controller is not yet powered up, power it up now.
11.
Open an Internet browser window on your computer.
12.
In the browser’s Address field, enter the default static IP address of the controller:
192.168.6.6
13.
The Integrated Configuration Tool starts. At the password screen, enter your username and
password. The default is
install, install
. We recommend that you change this default.
Connecting and Starting the Tool
If this is the first time setting up this controller, you will need to follow special directions. Refer to
Initial Configuration on page 65 . Otherwise, follow the steps below to start the Integrated
Configuration Tool (ICT).
To start the Integrated Configuration Tool:
1.
Connect the computer to the RJ45 connector on the controller’s CPU board using a network hub
or standard Cat 5 cable.
2.
Open an Internet browser window on your computer.
3.
In the browser Address field, enter the IP address of the controller.