LEMAN PRC016, Руководство по эксплуатации, Страница: 27 / 38

Operating Manual & Parts List
ASSEMBLY (CONTINUED)
•
Use a hammer to carefully tap chuck securely onto the spindle.
Spindle Taper
Hammer
Head Angle
Locking Handle
Head Rotation
Locking Handle
Figure 10 - Secure Head Assembly
MOUNT DRILL CHUCK
Refer to Figures 11 and 12.
•
Be sure spindle taper and chuck taper are clean and dry.
•
Insert chuck key into chuck and turn key counterclockwise until
the chuck jaws are completely inside chuck.
Chuck Taper
Chuck Key
Figure 12 - Secure Chuck onto Spindle
MOUNT QUILL FEED HANDLES
Refer to Figure 13.
•
Thread the three quill feed handles into the threaded holes on
the pinion hub.
Pinion Hub
Quill Feed Handle
Chuck Jaws
Figure 11
–
Clean Chuck Taper and Retract the Chuck Jaws
•
Push chuck over spindle taper and twist chuck slightly to
release air trapped in taper.
Figure 13 - Install Quill Feed Handles
ADJUST V-BELT TENSION
Refer to Figure 14, page 7.
•
Open the pulley cover and loosen both motor lock knobs (one
on each side of the head).
•
Push motor back to apply tension to v-belt.
•
Correct tension is obtained when the v-belt can be flexed
approximately
3 /
8
”
at belt midpoint using finger pressure.
6
EN