8
3.3 Making an outgoing call in Computer mode
• Ensure that the computer button on the top of the headset base is selected
• Press the headset’s ON/OFF button
• After finishing your call, press the ON/OFF button to disconnect
• You may also need to click your softphone’s disconnect button to end the call
3.4 Making a call in Bluetooth mode
• You must first connect your Bluetooth device . Follow the steps in section 2 .7
• Turn your headset on and make sure the Bluetooth mode is selected
• Place your call on your device as you normally would
• Depending on your device’s settings, you may need to change the audio source
on your device to ‘DECT Headset’ (most phones will automatically connect)
• Once you’re done with your call, either press the ON/OFF button on your headset or
end the call from your Bluetooth device
3.5 Receiving a call in Bluetooth mode
• You must first connect your Bluetooth device . Follow the steps in section 2 .7
• Turn your headset on and your call will automatically be answered
• Once you’re done with your call, either press the ON/OFF button on your headset or
end the call from your Bluetooth device
3.6 Making a call using UniBase® mode
Your SmartSet is equipped with UniBase technology that allows you to conference calls from
your office phone, computer, or Bluetooth together . You can conference up to two of these
devices at once
• To activate UniBase mode, start a call on your first device
• To conference in the second device, press and hold either the Telephone, Computer,
or Bluetooth mode button
• After about 4 seconds, the LED lights for the two selected devices will light up
• To exit UniBase mode, press any Mode button on the top of the base
• Note: All sounds from your computer will be shared with the conference call
