48
19. Disposal
The customer is responsible for disposing of the machine in accordance with regulations.
The machine is made from a range of metals and plastics. Make sure that the machine is disposed of in accor-
dance with local environmental protection requirements.
Leister Technologies AG, Galileo-Strasse 10, CH-6056 Kägiswil, Switzerland
confirms that in the model made available
for purchase, this product fulfills the requirements of the following EU directives.
Guidelines:
2006/42, 2014/30, 2014/35, 2011/65
Harmonized standards:
EN 12100, EN 55014-1, EN 55014-2, EN 61000-6-2, EN 61000-3-2,
EN 61000-3-3, EN 62233, EN 60335-1, EN 60335-2-45, EN 50581
Name of authorized representative for documentation: Volker Pohl, Manager Product Conformity
Kaegiswil, 7/14/2016
Bruno von Wyl, CTO
Andreas Kathriner, GM
18. Declaration of Conformity
20. Quick Reference Guide
20.1 Switching
on/Starting
20.2 Switching
Off
1. Swivel the hot-air blowers (8)
upward (stops the drive motor).
2.
Switch off the heater with the
Heater On/Off button
.
3.
Wait for the end of the cool-down process (approx. six minutes).
4.
Switch off the
main switch (5).
5.
Pull out the supply voltage plug.
1.
Make sure that the
main switch (5)
is switched off and the
welding nozzle (12)
is in
parking position.
2.
Connect the pneumatic system. Check the pneumatic regulator to see whether at least
6.5 bar is available.
3.
Connect the supply voltage plug.
4.
Switch on the
main switch (5)
.
5.
Switch the
welding nozzle (12)
and
transport rollers (9)
to AUTO.
6.
Select/set the welding parameters.
7.
Switch on the heater with the
Heater On/Off button
; wait three to five minutes until the
desired temperature is reached.
8.
The welding process automatically starts when the
pedals (7, B)
are pressed.
