26
iCONgrade, Operation
2.3
Setting a Reference Height
Inspection
When a sensor is selected the control panel automatically uses the last set reference height
for that sensor.
There are two ways to change the reference:
•
Manual mode
•
Seek mode
Manual mode
Use the
/
keys to change the reference height up or down.
Seek mode
Press the
and
keys simultaneously to enter the seek mode. In seek mode the screen
shows the current sensor value of the selected sensor.
Pressing both keys simultaneously again exits the seek mode.
Or press
or
for seek mode.
While in Seek Mode, the height values at the top of the
screen will be green.
If both keys are pressed, and held for more than
three seconds, the control panel will take the current
sensor value and store as the new reference height.
While holding these buttons, the
key will change
from
Seek
to
0.0
. Once the new reference height has
been set, the height values at the top of the screen will
change back to black.
