2020-02
CANVASA II + II can filling machine operating manual
23
7.
Setting up the machine
Touchscreen
Menus with messages, parameters and position information are displayed on the touch screen.
Menus can be accessed and parameters can be entered using the touchscreen.
Basic principles
The machine is normally set up by LEIBINGER service technicians during initial commissioning
and handed over to the customer ready for operation.
The following sections of the chapter "Setting up the machine" must, however, be observed, in
particular if the machine is not set up and commissioned by LEIBINGER service technicians, e.g.
after a change of location.
Place of set-up
The place of set-up must fulfil the following requirements:
The floor must be free of vibrations, level and have a corresponding load-bearing capacity
The machine must not be set up in potentially explosive areas
The ambient conditions specified in the technical data must be complied with.
Do not set up any heat sources, such as radiant heaters, in the immediate vicinity of the ma-
chine. Components sensitive to heat, such as plastic covers or electronic components, will
be damaged.
Space requirements
The required space is stated in the overview plan of the machine. The machine must also be
freely accessible from all sides.
A working area of approx. 1.5 m around the machine must be reserved for cleaning and mainte-
nance work.
Repositioning and aligning the machine
The machine is mounted on four rollers and can therefore be moved. The brakes of the rollers
must be fixed if the machine is at the desired location.
The machine is aligned using the four nuts on the threaded rod of the rollers.