Doc No. FM0855 issue 2 Page 13
10. DRAYTEK VIGOR AP 903 ACCESS POINT
STATUS LED INDICATORS
There are 9 sta
tus LED’s on the f
ront of the Access Point, see the table below;
LED Ref.
Status
Meaning
ACT
Blinking
Operating normally
Off
Power off
USB
Off
USB device not connected
On
USB device connected and ready
Blinking
Data is being transmitted via USB
2.4G
On
2.4GHz Access Point is active
Off
2.4GHz Access Point is turned off
Blinking
Data is being transmitted on the 2.4GHz interface
5G
On
5GHz Access Point is active
Off
5GHz Access Point is turned off
Blinking
Data is being transmitted on the 5GHz interface
LAN A1
Blinking
Data is being transmitted on the Ethernet LAN A1-A4
On
Ethernet LAN A1 is connected
Off
Ethernet LAN A1 is disconnected
LAN A2-A4
Off
Ethernet LAN A2-A4 is disconnected
On
Ethernet LAN A2-A4 is connected
Blinking
Data is being transmitted on the Ethernet LAN A1-A4
LAN B
Off
Ethernet LAN B is disconnected
On
Ethernet LAN B is connected
Blinking
Data is being transmitted on the Ethernet LAN B
STATUS LED’s
WHEN USED WITH XT2
The 2.4G and 5G LED’s s
hould be on
The ACT and LAN
A1 LED’s should be blinking
The USB and LAN A2 to LAN A4 and LAN B
LED’s
should be off.
DISABLE STATUS LED’s
It
is possible to turn all the LED’s off
if desired.
Connect into the unit via the Ethernet connection, Login and go to the
System Maintenance
menu then
select
Management
. In the
“
Panel Control
”
section set the
Disable LED checkbox then press OK.
Refer to the Draytek Vigor AP 903 quick start & user guide for more information (see section 6).