36
NOVO Technical Handbook - NE41 15013-02 v2.0
Plug&Play programming
To enter Plug&Play programming from the Service Menu, press
Alarm Button (B1)
.
Novo will confirm your choice by playing a short confirmation tone.
Novo is now in Plug&Play programming. Activate the peripheral (e.g. press alarm
button on SMILE) to register it in NOVO. A confirmation tone is played to confirm the
addition.
A Plug&Play compatible peripheral sends information about its own equipment type
in the radio message. This is used to determine how to register the peripheral in
NOVO.
When the peripheral has been added the unit returns to Service Menu and indicates
next function available with a voice message.
If the peripheral is already registered in another position or it does not support
Plug&Play the unit will play an
Error sound
and remain in Plug&Play programming.
Position programming
Position programming is to be used when adding a peripheral that is not a Plug&Play
device, i.e. does not include its own equipment type in the radio message.
When adding a peripheral in this way it is added to a specific transmitter position in
NOVO. The first 8 transmitter positions in NOVO are used in Position programming.
The configuration of these transmitter positions will determine how alarms from
them are handled. NOVO supports a large number of alarm types and configurations
for transmitters but below is the default configuration.
Position Denomination
1
User alarm from trigger
2
User alarm from trigger
3
User alarm from trigger
4
Smoke
5
Fall alarm
6
Door alarm
7
Bed alarm
8
Passive alarm
Table 23.
Default alarm types for the first 8 transmitter positions.
Please note that the table above shows a default configuration. Other configurations
may apply to your unit.
Position programming
is accessible when the unit has just entered the Add
transmitter function, before any other choice is made. To enter Position
programming, press the
Extra button (B3)
to choose the first
position
. The chosen
position is indicated with a number of short beeps corresponding to the position,
e.g. three beeps for position 3.
To step to the next position, press the
Extra button (B3)
again.
Activate the peripheral to register it at the chosen position. A confirmation tone is
played to confirm the addition, see
"Add transmitter". After a successful registration
the unit automatically returns to Service Menu.
