35
NOVO Technical Handbook - NE41 15013-02 v2.0
When a function has been executed, the unit automatically returns to the Service
Menu and a voice message describing next available function is played.
Select the function by pressing
Alarm button (B1).
Step to next function by pressing
Extra button (B3)
.
Exit function and return to Service Menu by pressing
Reset button (B2)
.
Exit Service Menu by pressing
Reset button (B2)
.
In Service Menu the
Alarm button LED (L1)
is lit and
Extra button LED (L3)
blinks.
#
IP/MOBILE
PSTN/MOBILE, PSTN+
PSTN
1
Add transmitter
Add transmitter
Add transmitter
2
Range test*
Range test*
Range test**
3
Remove transmitter
Remove transmitter
Remove transmitter
4
Toggle external MOBILE antenna Toggle external MOBILE antenna Toggle Home/Away/Passive
5
Toggle Home/Away/Passive
Toggle Home/Away/Passive
Toggle PABX
6
N/A
Toggle PABX
Table 22.
Service Menu functions available depending on carriers supported by NOVO.
*Range test in units with 4G or GSM available as a carrier includes both GSM coverage test
and a Walk test.
**Range test in units without 4G or GSM available as a carrier consist of Walk test only.
Add transmitter
When the unit enters Service Menu it directly plays a voice message indicating the
first function in the menu,
Add transmitter
, as the next function.
NOVO indicates that the function has been chosen by flashing LEDs L1 – L3 in
synchronization.
NOVO returns to Service Menu after 20 seconds of inactivity.
There are two different ways to add a transmitter to NOVO;
Plug&Play
and
Position
programming
.
Plug&Play is only available when adding transmitter that support Plug&Play. 40
Plug&Play transmitters can be added to NOVO via Plug&Play programming.
Position programming is available for all transmitters, 8 transmitters can be added to
NOVO via Position programming.
In total 48 peripherals can be added to NOVO.
When a peripheral has been successfully added a
confirmation tone
is played to the
speaker.
The radio message from the peripheral normally contains information about its
battery status
. That is indicated with the confirmation tone. The confirmation tone
is a short beep if the peripheral reported its battery status as
OK
. The confirmation
beep is a long beep if the peripheral reported its battery status as
low
.
If a peripheral is already registered in the unit at another position NOVO will play an
Error sound
instead of the confirmation sound. If registration is not successful, the
unit does not return to Service Menu.
