KITXWXSM1U
Installation Instructions
6
INSTALLATION
The KITXWXSM1U mount is designed to be mounted to:
•
a bare concrete wall with a minimum thickness of 8"
(203mm);
•
a bare 8" x 8" x 16" (203mm x 203mm x 406mm)
concrete block wall; or
•
wood studs spaced 24" or 32" (610mm or 813mm) on
center with a maximum drywall covering of 5/8".
The KITXWXSM1U has brackets which allow the TV to be tilted.
The KITXWXSM1U has static brackets which keep the TV in an
upright position.
Pre-Assembly
1.
Install the 7/8"-14 set screws (U) into the ends of the 42"
cross support rails (Z), then thread the 34" cross support
rails (Y) onto the set screws in the 42" rails. (See Figure 1)
Figure 1
2.
Slide rails through the first wall plate (S), then slide two tube
collars onto the rails. (See Figure 2)
3.
Slide rails through the second wall plate (S) and attach four
end caps (T) to the ends of the rails. (See Figure 2)
NOTE:
When installing with the FCAXV1U Pull-Out Accessory,
a third wall plate is used. Reference the Installation
Manual included with the FCAXV1U kit.
Figure 2
4.
Position collars (BB) over the seams between rails and
install two 1/4"-20 set screws (AA) into each collar. Rotate
rails to position screws towards underside of assembly.
(See Figure 4)
Figure 3
Locate Mounting Site
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! It is the installers responsibility
to make certain the structure to which the mount is being
attached is capable of supporting five times the combined
weight of all components located on the mount, not to exceed
250 lbs (113.4 kg).
NOTE:
If installing with the FCAXV1U Pull-Out Accessory,
reference the Installation Manual included with
FCAXV1U to install the accessory to the wall and
attach KITXWXSM1U to the accessory. Once installed,
proceed to the
Attaching Interface Brackets to
Screen
section in this document.
NOTE:
If not installing with the FCAXV1U Pull-Out Accessory,
proceed to either the
Installing to a Wood Stud Wall
section or the
Installing to a Concrete Wall
section.
Installing to a Wood Stud Wall
CAUTION:
MINIMUM HORIZONTAL DISTANCE
BETWEEN WALL BRACKETS IS 24" (610mm). Do not place
mounting brackets closer together than 24" (610mm). When
attaching to a wall containing studs located 16" on center,
space the uprights 32" (813mm) apart.
5.
Determine the center of the TV screen, and where it should
be located on the wall.
6.
Locate the closest stud to the left and right of the selected
location.
NOTE:
If the screen area lies over a stud, use that stud and the
stud to either the left or right of it.
Y (2)
Z (2)
U (2)
U (2)
CC (1)
(S) x 1
2
(T) x 2
3
(BB) x 2
2
(S) x 1
3
(T) x 2
3
BB (2)
AA (2)
Содержание CHIEF KITXWXSM1U
Страница 14: ...KITXWXSM1U Installation Instructions 14 ...
Страница 15: ...Installation Instructions KITXWXSM1U 15 ...