LEGRAND CHIEF KITXWXSM1U, Руководство по установке

Страница: 10 / 16

KITXWXSM1U Installation Instructions
10
Figure 13
IMPORTANT ! :
Completely extend bottom of interface
brackets (by pulling downward) to set interface brackets in
SERVICE position before hanging on top rail. (See Figure 14)
2. Hang top hook of interface brackets (W and X) onto the top
rail of the mount. (See Figure 15)
NOTE:
The screen initially installs into the "service mode" to
allow easy cable access.
3. Adjust screen and rails to desired viewing position, and
route cables between wall and rails.
CAUTION:
PINCH POINTS! Keep fingers, hands and
cables out of pinch point areas.
4. Open latch by pushing bottom of interface bracket up to
OPEN position, latching interface brackets to lower rail, and
then push up from bottom of interface bracket again until the
interface bracket is in CLOSED position. (See Figure 14)
Figure 14
Both interface brackets must NEVER be located
to one side of the wall brackets!
NEVER place both interface brackets to one
side of the wall mount center line (CL)!
Center Line (CL)
Latch in
SERVICE
position
Latch in
OPEN
position
Latch in
CLOSED
position