LEGRAND CHIEF KITXWXSM1U, Руководство по установке, Страница: 7 / 16

Installation Instructions KITXWXSM1U
7
7. Line up the notches on mount with center of screen marking
to determine vertical center. (See Figure 4)
8. Measure up 8" (203mm) from the center point to mark
location of the upper mounting slots.
9. Using a level, mark the wall on each stud to attach the
mount through the upper mounting slots. (See Figure 5)
10. Drill one 7/32" (5.5mm) pilot hole in each stud.
11. Partially install two 5/16 x 2-1/2" flanged lag bolts (J) into
pilot holes but do not tighten to wall.
12. Hang mount (Z), aligning upper mounting slots over lag
bolts and adjust side-to-side for proper location.
13. Place one slotted washer (L) over each flanged lag bolt.
(See Figure 5)
14. Tighten lag bolts to secure mount (Z) to wall at upper
mounting slots.
15. Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the studs.
(See Figure 5)
Figure 4
16. Drill 7/32" (5.5mm) pilot holes at markings for lower
mounting holes. (See Figure 5)
17. Use two 5/16 x 2-1/2" flanged lag bolts (J) and two 5/16"
slotted washers (L) to attach the mount to the wall through
the lower mounting holes. (See Figure 5)
18. Slide rails to approximate center of screen location.
19. Proceed to Locking Rails section.
Figure 5
Installing to a Concrete Wall
CAUTION:
MINIMUM HORIZONTAL DISTANCE
BETWEEN WALL BRACKETS IS 24" (610mm). Do not place
mounting brackets closer together than 24" (610mm).
1. Determine the center of the TV screen, and where it should
be located on the wall.
2. Line up the notches on mount with center of screen marking
to determine vertical center. (See Figure 6)
3. Measure up 8" (203.2mm) from the center point to mark
location of the upper mounting slots. (See Figure 6)
4. Using a level, mark the wall through both upper mounting
slots. (See Figure 6)
Center of screen
8"
Vertical center
of mount
(203.2mm)
15 16
9 10
11
14
(J) x 2
Mount
13
(L) x 4
17
(J) x 2
17