LEGRAND CHIEF KITXWXSM1U, Руководство по установке

Страница: 8 / 16

KITXWXSM1U Installation Instructions
8
Figure 6
5. Drill one 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot hole at each
marking.
6. Install an anchor (K) into each pilot hole using a hammer,
making sure that the anchor is flush with the wall.
7. Partially install two 5/16 x 2-1/2" flanged lag bolts (J) into
pilot holes but do not tighten to wall.
8. Hang mount (Z), aligning upper mounting slots over lag
bolts and adjust side-to-side for proper location.
9. Place one slotted washer (L) over each flanged lag bolt.
(See Figure 6)
10. Tighten lag bolts to secure mount (Z) to wall at upper
mounting slots.
11. Mark the attachment points for the lower mounting slots,
making sure the attachment points are located on the studs.
(See Figure 6)
12. Drill 3/8" x 3-1/2" (9.5mm x 88.9mm) pilot holes at markings
for lower mounting holes. (See Figure 6)
13. Use two 5/16 x 2-1/2" flanged lag bolts (J) and two 5/16"
slotted washers (L) to attach the mount to the wall through
the lower mounting holes. (See Figure 6)
14. Slide rails to approximate center of screen location.
Locking Rails (Optional)
1. Lock rails into place using two 1/4-20 x 3/4" set screws (Q)
on mount upright (Z) and the 1/8" hex key (M). (See Figure 7)
2. Repeat for remaining mount upright.
NOTE:
To easily install upper set screw against upper rail,
place set screw (Q) onto hex key (M), and feed up into
hole while turning to tighten.
Figure 7
Attaching Interface Brackets to Screen
1. Align the center of the bracket (W and X) with center of
screen. (See Figure 8)
NOTE:
The diamond-shape holes in the bracket correspond to
the center of the mount.
Figure 8
11
5
6
4
12
x 4
(K) x 4
10
7 10 (J) x 2
(L) x 4
9
13
13 (J) x 2
(Z)
(Q) x 4
1
(M)
(M)
Center of bracket
(G)
(H)
(A-F)