LEGA
srl
Costruzioni Apistiche
–
via Maestri del Lavoro 23
–
48018 Faenza
www.legaitaly.com - Tel 054626834
–
Fax 054628279
–
P.iva 00043230390
15 / 36
3.1
CLUTCH ADJUSTMENT
A
djusting the clutch is an extremely
easy operation enabling to calibrate in
an ideal way, according to different
operator requirements, the pulling
force of the frame conveyor chain.
Too 'tight' a clutch adjustment may
cause problems and could even break
some frames when they are fed on
between blades. Conversely, too
'loose' a clutch adjustment would
prevent uncapping as the frame would
stop every time that even a minor
obstacle is encountered.
By using a size 4 Allen wrench, undo
the 4 screws securing the round
teflon guard on the rear of the control
panel.
By using a spanner, unlock the lock nut and
tighten or loosen the nut until the right
adjustment is obtained. Then replace the
guard before restarting the machine.
