Duet
LECTROSONICS, INC.
22
Installing two M2Ts into a Single Rack
Space
The M2T transmitter occupies a half rack space, and
comes with hardware to mount two (2) M2T Receivers
into a rack.
1. Remove the Trim Cap (Part #P1330) from both sides
of the front panel of the first M2T unit to be rack
mounted.
2. Remove the breakaway tabs on both sides of the
Chassis Cover Panel. This requires the use of a
flat-blade screwdriver inserted into the slots and
levering the tabs away on each side of the unit.
3. Insert the Flange Bracket (Part #27076) into the
open slot in the side of the Chassis Cover Panel.
4. Insert two (2) Cap Screws (Part #28885) through
the Rack Handle (Part #27082) holes and install
the Rack Handle onto the Flange Bracket through
the holes in the unit’s front panel. Firmly tighten
the Cap Screws using the long leg of the Hex
Wrench as shown.
5. Unless also installing a Front Mounted Antenna,
insert the Hole Plug (Part #35959) into the open
antenna hole in the Flange Bracket by aligning the
flat sides of the plug with those of the bracket hole
and pushing into place until flush.
