Digital IEM System
Rio Rancho, NM
17
Operating Instructions
IR (infrared) Port
Settings, including frequency, name, limiter, mix mode,
etc. can be transferred to and from the M2T transmitter
via this port to an IR enabled receiver to simplify setup.
USB Port
For firmware updates and connection to Wireless De-
signer Software.
Reset Button
For MCU recovery in the event of an interrupted firm-
ware update.
Headphone Volume Adjustment
Adjust the headphone volume, and select source with
A1, A2, B1, B2 buttons.
Antenna Output Jacks
Two standard 50 ohm BNC connectors can be used
with whip antennas or coaxial cable connected to
remote antennas.
Dante Ports (optional)
A Dante Digital Audio Network Interface.
Ethernet Port
Used for setup, monitoring and control with Wireless
Designer Software.
Power Inlet
The threaded-locking DC coaxial jack accepts 9-18
VDC and draws 1.2A maximum.
Power Screens
When powering on the M2T, there are three screens
that appear in the following order, Duet, Lectrosonics,
RF On/Off.:
WARNING: If RF ON is selected and the
user chooses to “Do Not Show Again”
RF transmissions will be on when M2T
is powered on and may interfere with
frequencies already in use. This can be reset
in the FRONT PANEL menu.
Navigating the Menus
All Menu setup items are arranged in a vertical list on
the LCD. Press MENU/SEL to enter the menu, then
navigate with the UP and DOWN arrows to highlight
the desired setup item. Refer to the menu map on the
following page.
Press MENU/
SEL to enter
the menu
Press the UP and DOWN arrows
to navigate and highlight the
desired menu item
Press MENU/SEL
to enter the setup
of the highlighted
item
Press BACK
to return to
the previous
screen
Press the UP and DOWN arrows
to navigate and highlight the
desired item
