Digital IEM System
Rio Rancho, NM
23
6. Install the Front Tie Bracket (Part #25991) into the
open inboard slot in the side of the Chassis Cover
Panel with the protruding nuts facing rearward, af-
fix with two (2) Cap Screws (Part #28885) provided
and firmly tighten with the Hex Wrench. (See front
view image above.)
Repeat Steps 1 – 6 on the mating/opposing side of
the second M2T unit.
7. Use the Hex Wrench to remove the two (2) inboard
Cap Screws from the rear of the two (2) units to
be co-joined. Install the 25990, Rear Tie Bracket
to the rear panels of the two (2) units, reusing the
four (4) Cap Screws previously removed and firmly
tighten with the Hex Wrench. (See rear view image
above.)
The co-joined dual-racked M2T units are now ready
for installation into a rack.
NOTE: If supplied rubber foot/feet are installed on
under side of M2T, it will not fit in rack.
Rack flange
bracket
Rear bracket
Cap screws
Rack handle
Front bracket (not shown;
located behind faceplate)
Hole plug
Cap screws
M2T Front View
M2T Rear View
STEP 6
STEP 7
