9
5
1
14
15
15
1
6
4
28
5
30
31
3
4
2
25
27
3
31
35
2
Attach the Front Leg (4) to the Frame (3) with
an M10 x 19mm Screw (5), an M10 x 66mm
Bolt (28), an M10 Washer (30), and an M10
Locknut (31).
Do not tighten the Screw or the
Locknut yet.
4.
5.
6.
Grease
Apply some of the included grease to an M10 x
63mm Bolt (25).
Attach the Frame (3) to the upper set of holes
in the bracket on the Crossbar (2) with the M10
x 63mm Bolt (25) and an M10 Locknut (31).
Do
not overtighten the Locknut; the Frame must
pivot easily.
Next, tighten the Lock Knob (27) into the bracket
on the Crossbar (2) and into the Frame (3).
See the inset drawing. Insert the Lock Pin (35)
into the lower set of holes in the bracket on the
Crossbar (2).
Locking
Pin
Locking
Pin
Locking
Pin
Insert the Backrest Support (14) into a set of
holes in the Uprights (1). Rotate the Backrest
Support so that the locking pin is wrapped
around the Upright (see the inset drawing).
Next, insert a Weight Rest (15) into an Upright
(1). Rotate the Weight Rest so that the locking
pin is wrapped around the Upright.
Attach the other Weight Rest (15) in the
same way. Make sure that the Weight Rests
are at the same height.
See steps 2–4. Tighten the M10 Locknuts
(31) and the M10 x 19mm Screw (5) used in
these steps.
