4. OPERATING PROCEDURE
21
4. OPERATING
PROCEDURE
This chapter describes the basic operating procedures of the LT 450. Carry out the steps below
to configure the output signal.
Figure 4-1 Operating procedure
1
Press the power switch to turn the LT 450 on.
Initialization starts when you press the power switch. The LT 450 will not transmit normal
signals or accept key inputs until the initialization is complete. When initialization is complete,
the LT 450 displays the output format.
The LT 450 does not store the panel settings when you turn off the power. The panel settings
that are used at power-on are those that have been saved according to section 8.7.2,
“Power-on Panel Settings.”
2
Set the output format.
First, turn the jog dial to select the output format. Then, specify the SYNC, COMPONENT,
and ASPECT settings. (The settings may not be available depending on the selected output
format.)
See chapter 5, “Output Format.”
3
Set the output pattern.
First, press the pattern selection key to select the output pattern. Then, specify the settings
for SATURATION, GBR (YP
B
P
R
), and INVERSION. (These items may not be available
depending on the selected output pattern.)
See chapter 6, “Output Pattern.”
4
Connect a cable to the output connector and transmit the signal.
See chapter 7, “Output Connectors.”