Le Chai LMV1380D, Руководство пользователя

Страница: 37 / 60

17
EN
PROBLEMS AND SOLUTIONS
LED light (C) does not light up with the door open
Check if:
• The power cable is not inserted in the socket or not
inserted enough to make contact;
• There is no power in the house.
The wine cabinet is not cooling properly or the
compressor is running continuously
Check if:
• The door is closed properly or the seal is damaged;
• The door is opened too frequently;
• The installation conditions are met.
The appliance makes too much noise
Check if:
• The appliance is levelled properly;
• The appliance has been installed between furniture that
vibrates and makes noise;
• The installation conditions are met.
• The thermostat is on the right setting;
• The internal fan is free and unobstructed;
• This is the noise made by the refrigerant, which occurs even
when the compressor is switched off (this is not a fault).
The inner rear wall of the appliance is covered with frost or
water droplets.
Check if:
• This is the normal operation of the device.
There is water in the lower inner part of the appliance
Check if:
• The drain hole is not blocked.
A certain amount of water is normally present in the water
drain, which will ensure good moisture control in the
appliance.
If, despite all these checks, the appliance still does not work and
the problem persists, contact your nearest service centre,
indicating: type of fault, model ( Mod. ) and the Serial Number of
the appliance ( SN ) available on the data plate on the back of
the appliance.
Never use unauthorised technicians and always reject spare
parts that are not original.
Only for controller B
Check the table codes and corresponding actions:
Controller B will display an alarm or warning code if something is not
as expected.
This message will appear alternately with the internal
temperature until the alarm conditions stop.
The alarm can be switched off by pressing any key.
Please refer to the table below to understand the meaning of
the code and what action to take when it arises.
CODE CAUSE ACTION
dA Door open warning
Close the door or, if you need to have the door open for a loading/unloading operation,
stop the alarm by pressing any button. When you have finished, make sure you close the
door and the LED light should go out.
FIL Carbon filter change
Change the carbon filter and reset the counter by pressing the filter button (20). See
"Appliance Maintenance" for more details.
Even if this message appears, the appliance continues to operate normally.
HA High temperature alarm
This message appears if the controller is not able to bring the internal
temperature to the setpoint.
Check that the appliance is installed correctly and that the climatic conditions
in the room are as specified (see "Installation section).
If there has been a setpoint change, a large load change or a long door opening,
press any key to stop the alarm and allow the cabinet to stabilise.
If you are unable to resolve the problem, contact your local after-sales centre.
LA Low temperature alarm
HHA High humidity alarm
This message appears if the controller is not able to bring the internal humidity to
the setpoint.
Check that the appliance is installed correctly and that the climatic conditions
in the room are as specified (see "Installation section).
If there has been a setpoint change, a large load change or a long door opening,
press any key to stop the alarm and allow the cabinet to stabilise.
If you are unable to resolve the problem, contact your local after-sales centre.
LHA
Low humidity alarm
P1
Thermostat sensor failure
Contact your after-sales service, with this fault your appliance will stop working.
P3
Humidity sensor failure
Contact your after-sales service, with this fault your appliance will stop controlling
the humidity.