Le Chai LMV1380D, Руководство пользователя

Страница: 36 / 60

16
EN
MAINTENANCE OF THE APPLIANCE
Before doing any cleaning, disconnect the appliance from
the electricity (by removing the plug or turning off the main
switch in your home).
Defrosting
WARNING: Do not damage the refrigeration system.
The interior of the appliance should be cleaned regularly. Use a
soft cloth and a mild detergent and water solution. Do not use
abrasive products, acetone-based thinners or alcohol-based
products.
Remove all accessories (shelves, drawers, etc.). Wash with
warm water and a mild, odourless detergent (e.g. dishwashing
liquid), rinse with water containing bleach and dry thoroughly.
Wash the inside walls in the same way; pay particular attention
to the rack brackets.
Wash the door seal and also clean under the seal.
After cleaning the interior, rinse well with clean water and dry
thoroughly. When the appliance is cleaned, reconnect your
machine following the instructions in the "Installation" section.
Cleaning the condenser
It is recommended that the rear grille (condenser) be cleaned
once a year. You can use a vacuum cleaner or a soft brush. This
keeps energy consumption low.
Prolonged period of inactivity
If the appliance is not used for long periods of time, it is
advisable to unplug it and leave the door open to prevent the
formation of bad odours or mould. Check that the drainage
system (I) is clean. If necessary, remove the water with a
sponge and clean the hole with the brush provided.
Replacing the carbon filter
In order to maintain adequate air quality, the charcoal filter (J)
should be replaced once a year. Remove the old filter from the
holder and insert the new one, taking care to align it with the
fittings.
You can purchase new filters from your dealer. The default
period of use is 365 days.
Controller B displays the message "FIL" during filter
replacement. If this happens, press any button on the controller
to stop the audible alarm, change the filter as indicated and
press the filter button (17) to reset. You can change it by
pressing the filter button (17) for 3 seconds, pressing the button
to increase (13) or decrease (14) the number of days (Controller
B). Press the filter button again
(17)
again to exit settings mode.
Selecting zero value (zero days) will disable the filter function.
Replacing the light bulb
This appliance consists of LEDs (C) of energy efficiency
class F for appliances with controller A and energy
efficiency class E for appliances with controller B . This type
of diode cannot be changed by the consumer. The life of these
LEDs is sufficiently long that no changes need to be made. If,
however, despite all the care taken in the manufacture of this
appliance, the LEDs are defective, please contact your After
Sales Service if any intervention is needed.
This appliance is not designed for use as a built-in
appliance