LazyMan LM210-28, Инструкция по использованию и уходу

Страница: 9 / 34

LM210 SERIES ISLAND INSTALLATION- BUILT-IN MODELS
NOTE: Use this INSTALLATION section in conjunction with the following ‘GAS CONNECTIONS’ section to assure that all
gas considerations have been made before installing your grill.
INSTALLATION- USING NG GAS: After the island has been constructed and built per the previous cutout
recommendations and guidelines, it’s now time to install the LazyMan 210 Series grill into the island. The above diagram
shows a typical Natural Gas installation where the gas piping is routed through the back of the island and externally to
the gas source. This routing can also be accomplished internally (inside the island) if the island is constructed with a
hollow design and there is space between the back wall of the cutout and the back wall of the island. This grill is shipped
with a ½ NPT (female) fitting at the end of the gas manifold for both NG connections and LP hose connections. It is also
shipped with an NG regulator (for natural gas grills) and an LP regulator with hose for grills set up for liquid propane.
It is highly recommended that a qualified plumber or gas technician make this installation and perform the gas hook-
up procedure.
1. Measure the distance from the back of the cutout to the back of the island. You will need a ½” pipe with ½”
NPT male threads at both ends that match this distance plus 2”. This pipe is called a ‘nipple’. Nipples come
pre-threaded at both ends and are available in a variety of different lengths.
2. Use pipe joint compound or Teflon tape (to seal the threads) FOR ALL PIPE CONNECTIONS and install this
first pipe into the fitting at the back of the grill.
3. Using two or more people, carefully lift the grill into the island cutout and slide the grill toward the back of
the cutout. Allow the newly installed pipe to slide through the pre-cut hole or opening and through the back
5