LAZBOY Limited, Руководство пользователя, Страница: 21 / 60

Page 19
For HELP, call In-Touch at 866.461.3123
Operational Checks
Caution: Do not turn on any pump until your spa is properly filled with
water. Running any pump without water in your spa can
cause IMMEDIATE damage, which is not covered under
warranty!
By now you have rechecked your tub’s mechanical connections and filled
it with water to about 1” above all jets by adding cold tap water through
the pre-filter (if equipped). Turn on power to the spa at the main breaker
panel and test the operation of the electrical system. If you encounter a
problem, please reference the troubleshooting guide on page 40.
1. Turn on the breaker and test the operation of the Ground-Fault
Circuit Interrupter (GFCI) breaker by pushing the small button. This
should automatically trip the spa's circuit breaker.
DANGER: If this breaker does not trip, immediately call your
electrician. Do not use your spa!
Only if pushing this button successfully trips this circuit breaker
should you reset this breaker and proceed to the next step.
2. Go to the topside
control panel and look
at the display. The
system goes through
a startup sequence
after which the
circulation pump
starts and the panel
displays the current
water temperature.
Function
(4 buttons)
Back
Mode
Forward
Increase
Decrease
Next Page
OK
Figure 12 – Topside Buttons
3. Press the Pump 1 button . You should hear the first pump turn
on, see water circulating in the spa, and see the icon swirl on the
display.