LAZBOY Limited, Руководство пользователя, Страница: 19 / 60

Page 17
For HELP, call In-Touch at 866.461.3123
Before Adding Water
Before adding water, go through these simple steps now to prevent
common issues when setting up your
spa for the first time. Verify that the
following have all been rechecked.
1. Turn off all power to the spa at the main breaker panel.
2. Open the side panels to access the internal components.
3. Check that all slide valves are opened
(T-handles pulled out) to the heater and
all pumps.
4. Check that there are no obvious signs of
loose wires or broken pipes.
Figure 9 - Valve Open/Closed
5. Check that the two heater unions are
tight.
Caution: Do not use a wrench. Over-
tightening may cause
damage to unions and
gaskets, which will not be
covered under warranty.
Figure 10 - Unions Tight
6. Check that the unions on all pumps are tight.
7. Clean out any foreign debris from within the service access area or
inside of the spa itself.
8. With the drain open and filters removed, thoroughly rinse out the spa
with warm water until the drained water runs clear. Run water
through the filtration canister and jet lines to remove any incidental
dust, dirt, and debris that may have accumulated during shipment or
installation. Drain all water completely.
9. Make sure that the spa drain valve is closed and the cap is on tight
(see page 45).
10. Install the filter(s) in the filtration canister.
11. Check that all of the
spa jets are open (turned full counter-
clockwise).
12. Now is the best time to clean and polish the surfaces of your spa
(see page 44-47).