LawnMaster PB Series, Инструкция по безопасности и эксплуатации

Страница: 10 / 34

10
A STEELFORT PRODUCT | STEELFORT.CO.NZ
CAUTION
• To minimize gum deposits in your fuel system
and to ensure easy starting, do not use petrol
left over from the previous season.
• Pressure can build up in the fuel tank. Allow
the generator to cool for at least two minutes
before removing fuel cap. Loosen the fuel cap
slowly to relieve any pressure in the tank
5. ELECTRICAL DEVICES
Disconnect all electrical devices from the generator
and switch off the AC circuit breaker before starting
the engine.The generator may find it hard to start
with electrical devices connected.
6. GROUNDING
The generator must be properly connected to an
appropriate ground. It helps prevent electrical shocks
if a ground fault condition exists in the generator or
in connected electrical devices, especially when the
unit is equipped with a wheel kit. Proper grounding
also helps dissipate static electricity, which often
builds up in ungrounded devices.
DANGER
ELECTRICAL SHOCK
Failure to properly ground the generator can result in
electric shock. A ground terminal on the frame of the
generator has been provided. For remote grounding,
connect a heavy gauge (4 mm) copper wire between
the generator ground terminal and a copper rod
driven into the ground.
The National Electrical Code requires that the frame
and external electrically conductive parts of this
generator be properly connected to an approved
earth ground. Local electrical codes may also require
proper grounding of the unit.
We strongly recommend that you consult with a
qualified electrician for grounding requirements in
your area.
7. STARTING THE ENGINE
7.1 Perform operating checklist.
7.2 Turn fuel valve to the “ ON “ position.
7.3 Turn off AC breaker protector.
7.4 Pull the choke valve switch to “ON” position.
OPEN CLOSE