LawnMaster PB Series, Инструкция по безопасности и эксплуатации

Страница: 20 / 34

20
A STEELFORT PRODUCT | STEELFORT.CO.NZ
4. Remove the oil drain plug and allow the oil to drain
completely.
5. Fully tighten the drain plug.
6. Add recommended oil to the upper limit (see add
oil instruction above).
7.Reinstall & fully tighten the dipstick.
8. Dispose of used oil at an approved waste manage-
ment facility.
WARNING
The engine is not filled with oil at the factory. Any
operation before it has been properly filled with the
recommended type and amount of oil may result in
engine damage and void your warranty.
3.6 AIR FILTERS
1. Loosen the filter fix bolt and remove the cover
of the air filter.
2. Remove the foam filter element.
3. Wash in liquid detergent and warm water
4. Squeeze thoroughly dry in a clean cloth.
5. Saturate in clean engine oil.
6. Squeeze in a clean, absorbent cloth to remove
all excess oil.
7. Place the filter in the assembly.
8. Fasten the air filter cover with the fix bolt, and
the mounting it back to the air filter body.
WARNING
DO NOT run the engine without the air filter as this
is dangerous can result in personal injury and or
damage.
3.7 SPARK PLUG
1. Clean any dirt from the spark plug cap and
spark plug base.
2. Remove the spark plug cap.
3. Using socket wrench to loose and remove the
spark plug.
4. Inspect the spark plug and spark plug washer,
if it’s damaged or worn, replace with new one.
Clean the spark plug with wire brush if reuse it.
5. Check spark plug gap. Carefully bend side
electrode to adjust the gap if necessary.
SPARK PLUG GAP: 0.6MM - 0.8MM
6. Carefully thread the plug into the engine by
hand.
7. After the spark plug is in position, use spark
plug wrench to tighten the plug.
SPARK PLUG TIGHTEN TORQUE: 15-20 N.M
8. Attach the spark plug wire to the plug.
WARNING
Only use the recommended spark plug or equivalent.
DO NOT use spark plugs that have improper heat
range.
3.8 SPARK ARRESTER
(Applicable types)
1. Allow the engine to cool completely before
servicing the spark arrester.
2. Remove the two bolts holding the cover plate
which retains the end of the spark arrester to
the muffler.
3. Remove the spark arrester screen.
4. Carefully remove the carbon deposits from the