LawnMaster PB Series, Инструкция по безопасности и эксплуатации, Страница: 15 / 34

15
A STEELFORT PRODUCT | STEELFORT.CO.NZ
WARNING
NEVER stop the engine with electrical devices con-
nected and with the connected devices turned “ON”.
3. Allow the generator run at no load for a few min-
utes to stabilise internal temperatures of the engine
and generator.
4. Turn off the flameout switch (turn the engine
switch to “OFF’’ position).
5. Turn fuel valve to ‘‘OFF’’ position.
12. LONG DISTANCE CONTROL
(Applicable Types)
STEP 1.
Installation of the generator is extremely simple.
Both the start-up and stop functions are built into the
generator itself and so it is not necessary to have an
external control box.
The generator can be started by a remote signal
through the normal open contact photovoltaic
installations.
It is imperative that the inverter charger is available
in order to do the startup process of the generator.
Below is an example of an off grid photovoltaic
installation.
Note: The following diagram is only indicative, a
general idea to understand the operation process.
Consult a professional and or installer to perform
correct installation.
STEP 2.
Understanding The General Operation.
The generator is designed to support photovoltaic
installations. The generator will provide power when
the solar energy is not enough.
This generator has been designed for an automatic
start and stop, commanded by an inverter/charger.
The inverter/charger can detect low battery levels
during operation. Similarly, the inverter charger will
send a stop signal to the generator if charging is
required. Not all inverter/chargers remotes from
generator connect with each other, consult your local
service dealer for more information.
230 V power input connection:
The automatic mode of the generator consumes very
little power when active.