LawnMaster LGBQH6200, Инструкция по безопасности и эксплуатации

Страница: 13 / 26

13
A STEELFORT PRODUCT
Before the operation, please do a routine inspection
of the oil. The recommended maintenance interval
can be found in the maintenance section.
CAUTION
When the generator can not be started through the
electric start, please open the left maintenance pan-
el, and start the generator through the choke handle
and the start handle together.
After completing the above operations, the generator
can be connected to the electrical devices. When
the electrical devices require high initial power,
please turn the energy-saving switch to “OFF” posi-
tion. When no more initial power is needed, please
turn the energy-saving switch to “ON” position.
WARNING
When the generator output terminal is connected to
the electrical device and the electrical device is on, it
is prohibited to start or shut down the generator.
CAUTION
Do not continue to start the generator before the
fault is removed. It is forbidden to start the generator
after using other batteries without authorization.
STARTING THE GENERATOR WITH LGP
(IF EQUIPPED)
1. Perform pre-use inspection items and remove
all loads
2. Connection steps of relief valve assembly,
generator and fuel cylinder
Attach the relief valve hose assembly (threaded end)
to the fuel cylinder valve and tighten it.
Remove the shields from the generator LPG female
connector and relief valve pipe male connector.
Align the upper male connector of the relief valve
pipe with the generator LPG female connector and
insert it until you hear a “click” sound, indicating that
the relief valve pipe and the generator LPG female
connector are firmly connected.
3. Open the fuel cylinder valve
4. Select according to the actual configuration
of the user
RECOIL START
1. Before starting the generator, turn the
combination switch to “START” position.
2. Hold the handle of the recoil starter and pull it
slowly until there is resistance, and then quickly
pull the handle to start the generator.
ELECTRIC START
Press and hold the start button in “ON” position for
0.3-5 s and then release it, and then the generator
will be started.