Operating Instructions
68
Part No. 70476501ENR7
Display
Definition
Corrective Action
AF (Flashing)
Bouncing Airflow Switch
•
Check airflow switch to ensure that it is properly
aligned and securely mounted in the mounting bracket.
•
Make sure airflow switch can open and close freely.
•
Check installation and make sure there is adequate
airflow.
•
Make sure exhaust is not blocked.
•
Clean the lint screen.
•
Replace airflow switch if inoperative.
AF (Solid)
Airflow Switch Closed when Resuming
Cycle
•
Allow up to 20 seconds for this condition to clear.
•
Check if airflow switch opens at end of cycle.
•
Replace airflow switch if inoperative.
Table 13 Error Codes
Electronic OPL Micro Control
L and P Models with RM Control Suffix
1. To use an Automatic Cycle, press an ON/SELECT pad.
Select HIGH, MEDIUM, MED LOW, LOW or NO HEAT
for items that should not be dried with heat. A light to the
left of the selected pad lights up.
HIGH
Temperature 180°F
(82°C)
MEDIUM
Temperature 160°F
( 71°C)
MED LOW
Temperature 140°F
(60°C)
LOW
Temperature 120°F
(49°C)
To use a Time Dry or Custom Cycle, refer to the Programming
Manual.
Figure 29
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to
Figure 30
2. Select REVERSING or NONREVERSING cylinder
rotation setting.
TMB1 4 8 6 N_SVG
REVERSING
Figure 31
3. Press START pad to start tumble dryer.
Figure 32
NOTE: All pads can be pressed in any sequence
without damaging control or tumble dryer. To stop
the tumble dryer at any time, open the door or
press STOP/RESET.
Содержание LDR-900-S
Страница 2: ......
