Maintenance and adjustment
52
INSTALLATION, MAINTENANCE AND USER' MANUAL
549263_D_PUB_DATE_7_JUL_2014.DOC
Water filters
Machines are equipped with filters on water inlets. It is necessary to clean up the filters occasionally to
avoid a prolongation of filling the machine with water. Intervals of cleaning depend on the quality of the
water, for example foreign particles in the water line.
WARNING!
BEFORE YOU START CLEANING THE WATER FILTERS, CHECK IF ALL WATER INLET TO THE
MACHINE IS CLOSED.
Tightening moments
Standard torques are used on the machines - with the exception of the torques in the locations specified below:
o
Bolts securing the door lock
M5 – 2.5 Nm
o
Central bolt of the door handle
M6 – 8.8 Nm
o
Turning mechanism of the door handle
3.5 - 3.8 Nm
o
Bolts securing the door hinge,
front panel
M6 – 8.8 Nm
o
Anchoring bolts
M16 – 100 Nm
Freestanding machines
o
Spring holder bolts
M8 – 10 Nm
o
Bolts of the dampers
M10 – 24 Nm
o
Motor holder bolts
M12 – 45 Nm
o
Bolts of the weight
M8 – 26 Nm
o
Bolts of the tightening flange
of the external tub:
M8
M8
–
–
12 Nm – 7-8-11-14 kg / 15-18-25-30 lb
26 Nm – 18-24-28 kg / 40-55-65 lb
Rigid-mount machines
o
Bolts of the tightening flange
of the external tub
M8 – 26 Nm
o
Motor holder bolts
M12 – 5 Nm
Replacement washer fuses
Fuse values
The correct values of fuses can be found in the vicinity of the fuse holders and on the electrical scheme
and delivered with the machine. When a fuse is blown, you can replace it with the same value but in
NO
case
a higher value. If the fuse blows again, do not change it, but find the cause of the failure.
Contact your commercial distributor for help if necessary.
!
