LAUNCH X-631/X-631+ Wheel Aligner Operation Instructions
4-8
Fig.4.23
Attention: After adjustment, please remember to click
button, and then put down the vehicle body
according to the prompts on the screen. If the lift is not
put down, it will be limited to select the other interfaces
(except for [Front axle measurement] interface) as
shown in Fig.4.24.
Fig.4.24
Front axle measurement
This interface can provide the real-time result related to
front axle measurement, the operator can compare the
measurement result with the reference data while
adjusting the vehicle, until the vehicle is adjusted to the
best status. The interface is as shown in Fig.4.25.
Fig.4.25
[Double click]: Double click (with left key of the mouse)
on the data display forms for camber and toe-in of LR
and RR wheels, the corresponding displayed data will
be enlarged.
[Additional measurement]: This interface provides an
operating platform for special measurement, which can
measure and display left lateral offset, right lateral
offset, axle offset, front setback, rear setback, track
width difference and wheelbase difference, etc.
[Toe-in adjustment for the front wheel steering]: Click
to perform toe-in adjustment for front wheel
steering, and click
to center the steering wheel
(Note: When using two probe rods to perform the
measurement operation, only total toe-in is displayed,
and individual toe-in is not displayed).
[HELP for vehicle adjustment]: Click this button, the
screen will pop up an interface of [HELP for vehicle
adjustment], the different adjusting methods for various
vehicle models have been enumerated in this interface
for vehicle adjustment, the operator can perform the
vehicle adjustment operation according to the
operating methods in the HELP interface.
[Lift up vehicle body]: Sometimes it is required to lift the
vehicle body up in order to be convenient to adjust
front/rear camber and caster. When the vehicle wheels
are lifted up, the inclinometers will move, and the
corresponding measured values will change, too. In
this case, please use Lifting Adjustment function. Click
button, and then lift up the vehicle body
according to the prompts on the screen. The software
will automatically compensate the offset of inclinometer
in order to realize accurate adjustment.
Attention: After adjustment, please remember to click
button, and then put down the vehicle body
according to the prompts on the screen
[Toe-in curve change] provides the special
measurement methods relative to some vehicle models
of VOLKSWAGE and AUDI, etc. First, the operator
must adjust the toe-in curve changes of these kinds of
vehicles to the standard range, and then Front Axle
Measurement can be performed normally. When
[Toe-in Curve Change] is activated, please click the
icon of
, the screen will display the interface as
shown in Fig.4.26.
Double click
HELP for vehicle
adjustment
Lift up vehicle body
Additional measurement
Toe-in curve change
Содержание X-631 Plus
Страница 1: ......
