4 Before starting up
4.1
Install device
Special installation conditions apply to the devices. These installation condi-
tions are specified for the most part in the technical data for the device.
You will find further information on the technical data in
Chapter 11.1 “General data” on page 50
.
Additional installation conditions are described in the following.
n
Irritant vapors may develop, depending on the heat transfer liquid and
operating mode used. Always ensure that the vapors are adequately
extracted.
n
Note the electromagnetic compatibility (EMC) requirements of the
device.
n
Do not cover the ventilation openings.
You will find further information on the EMC requirements in
Chapter 1.4 “EMC requirements” on page 7
WARNING!
Danger of the device rolling away or overturning
Impact, crushing
Do not tilt the device!
Position the device on an even, non-slip surface with a
sufficient load carrying capacity!
Actuate the caster brake when setting up the device!
Do not place heavy parts on the device!
1.
Place the device in a suitable location in the room.
n
Place table-top devices on a suitable table. To do so, carry the
device with your hands holding the bottom of the device.
n
Place floor-standing devices on a suitable level surface.
Floor-standing devices can be moved. To do so, release the
parking brakes on the casters by pushing the
[Off]
lever
downwards.
You can position several devices next to each other.
2.
Lock the casters in the case of floor-standing devices. To lock, press
the [On] lever downwards.
V07
Microcool
22 / 57
