CrossLink LIF-MD6000 Master Link Board
Evaluation Board User Guide
© 2016-2018 Lattice Semiconductor Corp. All Lattice trademarks, registered trademarks, patents, and disclaimers are as listed at
www.latticesemi.com/legal
. All other brand or product names are
trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
FPGA-EB-02010-1.4
7
3.
Programming Circuit
The Mini-B USB connector is used for programming the board by using Lattice Diamond Programmer software.
Figure 3.1
shows the programming block of LIF-MD6000 Master Link board.
The Mini-B USB connector interfaces to the FTDI FT2232H IC. The FTDI IC works with Diamond programmer software to
provide interfaces for:
JTAG – to program MachXO2-1300E
SPI – to program both CrossLink, and SPI Flash Memory
USB Mini-B
(J2)
FTDI Chip (U1)
SPI Flash (U14)
LIF-MD6000
CSFBGA81 (U8)
LCMXO3LF-1300E
MG121 (U19)
JTAG
SPI
Figure 3.1. Programming Block
3.1.
Bridging Circuit
Figure 3.2
shows the block diagram of bridging of different standard interfaces. The CrossLink device is used as a
bridging device that supports a variety of I/O standards. This demo board supports development of the following
interface bridges:
1:1 MIPI DSI Display Interface Bridge
1:2 MIPI DSI Display Interface Bridge
2:1 MIPI CSI-2 Image Sensor Aggregator Bridge
CMOS to MIPI CSI-2 Image Sensor Interface Bridge
MIPI CSI-2 to CMOS Image Sensor Interface Bridge
MIPI DSI to CMOS Display Interface Bridge
OpenLDI LVDS to MIPI DSI Display Interface Bridge
CMOS to MIPI DSI Display Interface Bridge