7.5 P-4 Electronic keys
7 PROGRAMMING OF ENTRY PHONE
P-4-0
C 0 (U,H)
Resetting electronic key memory.
Procedure is used for resetting all keys stored in entry phone system memory.
4
0
1 2 3 4
Installing
specialist`s
code
Administrator code should be given to protect against accidental resetting. After
having given the code or having used the service key during resetting time on display
message CLR and tst will appear. Procedure results in resetting of all user‘s code
and service key codes which lasts approx. 5 sec.
P-4-1
Add (U,H)
Addition of key without attributing to apartment.
After applying the key to the reader its serial number will be read and stored in
4
C
1
CELL
NUMBER
IN MEMORY
entry phone memory. On the display the following messages will be shown Add ,
NEU and xx ,where xx is a number which defines number of memory cell in which
key number was saved. If the key has already been saved in entry phone memory
a message OLD will appear on the display. An installing specialists cannot change
the item in which key number is saved. The key is registered in the next free mem-
ory item. An installing specialist can make a list in which key position in memory
as well as the name of a person to which the key will be given. It is important in
the case when the key has to be deleted from the memory, however this method is
not comfortable.
P-4-2
L- - - (U)
Addition of key with attributing to apartment
Procedure enables adding of key and attributing it to selected apartment number,
4
2
1
0
END OF OPERATION
APARTMENT
NUMBER
POSITION
IN MEMORY
which facilitates keys management. The use of the key is signalled in uniphone
receiver as in the case of combination lock. Programming is realized as follows:
After activation P-4-2 on the display a flashing message will appear L- - - .
Give apartment number and confirm it with key KEY . Digit on the display
will flash slowly.
35
