Laskomex CD-2000, Инструкции по эксплуатации и программированию

Страница: 23 / 36

- 22 -
CD- Elementy systemu domofonowego 2500
actions:
1. After programming the MASTER key
2. Press the button – the opening time shall be increased by 1 s. By pressing the
button the appropriate number of times, set up the required lock operation time.
3. Remove the MASTER armament.
Attention!
After exceeding the time of 10s, the reader shall automatically set the minimum lock
operation time (1s), which shall be confirmed by a long acoustic signal.
Entering the procedure of adding and removing user keys.
In order to enter the procedure, apply MASTER key to the reader for a period of
approx. 5 s. Entering the procedure shall be confirmed with a single long acoustic
signal.
Adding new user
With the use of MASTER key, the installer can add or remove user keys. In order
to do this, one must perform the following actions:
1. Enter the user adding and removing mode.
2. Apply the key which is being introduced to the reader. Its number shall be added
to memory (unless it has been programmed earlier), which shall be confirmed y two
short sounds.
3. Repeat the operation for every added key.
4. After finishing entering the keys, apply the MASTER key for a period of approx.
5 s. The reader shall quit the programming mode, which shall be confirmed by a
long acoustic signal.
Attention!
If the maximum allowed number of programmable keys (508) is exceeded, the reader
shall automatically quit the programming mode, signaling this operation with four
short acoustic signals.
Removing users
Users entered into the system can be removed from it in either of two ways.
If the installer has the key whose authorizations are to be revoked, the following
operations should be performed:
1. Set the reader into programming mode.
2.For a moment attach the key which is being deleted to the reader: the device will
recognize that the key number is already in its memory, which shall be confirmed
by two acoustic signals.
3. Apply the Master key for a period of approx. 4 s.
4. Re-apply the MASTER key for a period of approx. 10 s in order to quit the
procedure.
If the installer does not have the key which he is about to remove, one should perform
the following operations:
1. Set the reader into programming mode.
2. If the door opening button is not connected to terminals Z+, 4, then connect any
short-circuit button in this place.
3. Find the number of the key to be removed in the user list.
4. Press the button the number of times equivalent to the read key number.
5. Apply the Master key to the reader for a period of approx. 4s.
Re-apply the MASTER key for a period of approx. 10 s in order to quit the procedure.