Laskomex CD-2000, Инструкции по эксплуатации и программированию

Страница: 11 / 36

- 10 -
CD- Elementy systemu domofonowego 2500
4.Programming.
The following symbols are used in description of programs:
6
Display view
Chosen symbol
NOTE NOTE NOTE
Time for selection of a given procedure is 60 seconds . If no procedure is selected
within this time normal operation mode will be restored automatically. Value of a
parameter in a given procedure can be selected during 6 seconds. If no new value
is entered within this time the [P-] level will be restored and old value will be
maintained even when a new parameter has been partly entered to the display. It
should be remembered that in operations related to flats (change of code, disabling
uniphones) the flat number must always be entered even when this number is higher
than 255. The system will calculate physical number of the uniphone in the system
taking into account a preset range shift value and type of numbering.
NOTE
After entering common code it is required to enter wireman’s code because the
time for this operation is limited.
4.1. Access to system procedures.
common
code
1
0
2
3
PIN
code
1
3
0
2
5
7
where PIN is a personal code of the installing wireman and 130257 is a common
code defined by the manufacturer, identical for all CD-2500 systems. The personal
code is factory set as a number from the predefined code table. The personel code
can be changed using suitable procedure. After correct selection of both the common
and peronal codes the system enters the programming mode, door phone operation
mode is stopped and message [P-] is displayed.
NOTE:
Enetred digits are not displayed, but sound-signalled only