Laskomex CD-2000, Инструкции по эксплуатации и программированию

Страница: 14 / 36

- 13 -
CD- Elementy systemu domofonowego 2500
Parameters of the door phone operation configuration:
2 9 9
old
value
0
new
value
parameter
P-2-9-1 -emergency mode enable
P-2-9-2 -emergency mode call by Err enable
P-2-9-3 -coded lock enable
P-2-9-4 -message “E” display disable
P-2-9-5 -code use confirmation enable
P-2-9-6 -ring to uniphone with removed handset enable
P-2-9-7 – sort of numbering (normal o r storey)
P-2-9-9 - minimum range of serviced apartaments
P-2-9-10 – maximum range of serviced apartaments
P-2-9-11 – first extra serviced number
P-2-9-12 – second extra serviced number
Parameter in P-2-9 procedure can be "0" or "1" value. Setting of this procedure
influence on accessibility of some functions for tenants. Example: One can totally
turn off functions of code lock (no possibility of entering any flat code), can turn off
confirmation of using code lock, can block emergency procedure function (opening
the code lock if the keabord is out of order) or can limit range of this procedure only
to wire defect. Acces to configuration follows after entering a code of function 9 in
procedure 2. In those situations a cursor (horizontal dash on the right side) is
displayed and it is required to enter the code of function and next to touch (key) to
store it. Then information of the function current state is displayed (1 if the function
is enabled, 0 when the function is disabled) and touch to store it.
All parameters and configuration are permanently stored, i.e. after switching off the
power supply information is kept in the memory.
P-3 Service program.
This program allows uniphones installed in flats to be checked without necessity for
assistance of other person. Key umbers of flats in which service works are planned
must be given (up to 15 numbers). After entering the last number switch the central
unit over to normal operation mode – any number can be called and the coded
lock codes can be used. This program is an extension of the P-1 program. During
the works normal operation of the door phone is possible. It is also possible to call
the control panel from the uniphone, pressing of the door opening button. After
detection of pulse signal, the system tries to make connections with other uniphones
specified in the program. The program can also be used during installation of the
system if it is known in which flats new uniphones are to be installed. The service
program comprises the following options:
-data input C+2
-data erasing C+3
To get access to the service program, touch “3” in [P-] level- message [P-3] is
displayed.
From the [P-3] level new numbers of flats can be entered or old numbers can be