LaserPro Spirit LS, Руководство пользователя

Страница: 58 / 62

Page 58
Spirit LS/GLS Engrave Settings
Note: ONLY These settings are to be used as a rough guideline as each individual laser tube can vary.
EEnnhhaanncceedd VVeeccttoorr IInnffoorrm maattiioonn
Enhanced vector is a mode used commonly with
cutting thick pieces of material that cannot be
cut in the default vector mode. This mode will
slow the machine down by up to 50% enabling
the laser beam to cut more material. The side
effect to this mode is it will also slow down your
engraving speed.
Depending on a laser cutters age the firmware
in the machine can vary and some laser cutters
will be set up to use the enhanced vector mode.
To tell if your machine is set up with this mode
simply look for the enhanced vector box to be
checked in the Advance tab in the print properties
setting. (See Right)
Note: If your enhanced vector box is ticked then all
you need to do when inputting your cut settings is
multiply your by two. cut settings only
Eg: If the chart recommends
2.0% Speed and 100% Power
on Enhanced vector the settings will be
4.0% Speed and 100% Power
Acrylic Polypropylene Fabric Balsa Wood Laser Ply Thin Card Boxcard 475mic Lino Cork Glass Correx Leather
Speed 100 50 100 100 100 100 100 100 100 100 50 100
Power 45 100 40 100 50 60 60 50 18 30 100 85
PPI 400 400 400 400 400 400 400 400 400 400 400 400
Speed 100 100 100 100 100 100 100 100 100 100 100 100
Power 25 90 20 75 100 40 50 40 8 20 100 55
PPI 400 400 400 400 400 400 400 400 400 400 400 400
Speed 100 100 100 100 100 100 100 100 100 100 100 100
Power 10 75 10 35 100 10 10 20 10 10 90 35
PPI 400 400 400 400 400 400 400 400 400 400 400 400
Speed 100 100 100 100 100 100 100 100 100 100 100 100
Power 8 65 8 25 90 7 7 15 7 7 50 20
PPI 400 400 400 400 400 400 400 400 400 400 400 400
60w
40w
25w
12w
Enhanced Vector Information