Page 49
Step 4.
figure 1
Plug the serial lead connection into the port located in the inside front of the laser
. Then you can screw the rotary fixture to the laser bed via the two
screw holes at the right hand side of the rotary attachment as shown in
figure 2.
Step 5.
Now take the cone out of the laser head, this will give you maximum clearance between the laser head and the highest section of the rotary attachment. To do
this simply remove the bottom two screws and loosen the top screw, then swivel the face plate clockwise. This will enable access to the cone which slides out of
the front of the laser head. Once the cone has been removed, replace the face plate to its original position and tighten the screws back up.
Loosen this screw
Remove these two screws
Before
the cone has
been removed.
After
the cone has
been removed.
Fig 1
Fig 2
Note
: This photo is from the
back
of the laser to
give a clear view of the port. The port connector
is on the inside front of the laser cutter.
