LaserLiner Revolution, Руководство по эксплуатации

Страница: 5 / 20

Revolution
21 ENGLISH
Single slope
function
Commander 50
In automatic mode, an axis can be manually set to a
certain slope using this function, even if the ADS tilt
function is also active. This means that one axis can be
re-adjusted whilst the other is aligned horizontally and/
or vertically. Press the slope/man button to activate the
function and select the X or Y axis. The slope LED lights
up, as does the LED for the X or Y axis. The slope is
re-adjusted using the plus/minus buttons. ATTENTION:
This function cannot be used to perform full horizontal
levelling, just to adjust one axis.
Manual slope
function
Commander 50
This function deactivates the automatic sensor, which
enables two axes to be re-adjusted simultaneously and
steep slopes to be set. To use the function, press the
slope/man button repeatedly until the man LED lights
up. Use the tilt button to toggle between the X and Y
axes. The plus/minus buttons are used to re-adjust the
slope by means of a motor. In vertical operation, press
the slope/man button 3 times to activate the manual
slope function for the Z axis. IMPORTANT: Since the
automatic sensor is not active, horizontal and/or vertical
levelling cannot take place.
Adjustment
mode
Commander 50
This mode can be used to re-adjust the device. With the
device switched off, press and hold down the slope/man
button. Then press the ON/OFF button briefly, keeping
the slope/man button pressed down until the X, Y and
Z axis LEDs light up simultaneously. Open the cover on
the Commander 50 and use the X/Y button to select
the required axis. Now use the plus/minus buttons on
the adjustment panel to set the selected axis; see the
"Adjustment mode" section for more information. In
vertical operation, the device activates the Z axis auto-
matically. Save your new setting by pressing the enter
button.
Power
management The device can be operated using the high-performance
rechargeable battery or standard alkaline batteries.