LaserLiner Revolution, Руководство по эксплуатации

Страница: 17 / 20

Revolution
33 ENGLISH
Adjustment mode
1. Take the alignment of the rotary laser into account when performing adjustment
work. Always adjust all the axes.
2. Switch the device to adjustment mode:
Switch off the Revolution and then switch it on again (press the ON/OFF but-
ton briefly), whilst holding down the slope/man button. Keep the slope/man
button pressed down until the X, Y and Z axis LEDs light up simultaneously.
Then you can release the slope/man button.
Use the X/Y button on the Commander 50 to toggle between the X and Y
axes.
Alternatively, you can toggle between the X and Y axes using the positioning
button (rotate to the right on Commander 50 or SensoCommander).
In vertical operation, the device activates the Z axis automatically.
3. Correcting the adjustment:
With the plus/minus buttons on the adjustment panel of the Commander 50,
you can move the laser away from its current position at the level of refe-
rence point A2.
NOTE: In spot mode, the laser can only be rotated to the required position by
means of the positioning buttons on the device.
4. Completing the adjustment:
Cancel: Switch the Revolution off (via the ON/OFF button) to reject all the
adjustment settings and restore the previous status.
Save: The new adjustment settings are saved by pressing the enter button on
the Commander 50.
Alternatively, you can save the new adjustment settings using the positioning
button (rotate to the left on Commander 50 or SensoCommander).
L
Note: Regularly check the adjustment before
use, after transport and after extended
periods of storage. Always make sure
to control all axes.
(13)
(1)
(1)
(20) (20)
(18)
(23)
(21)
(24)
(5)
(16)
X- / Y- /
Z-Axis
X
Z
Y
Adjustment panel